Livington iRon Flex Instrucciones De Uso página 10

Label reference
CLEANING AND MAINTENANCE
Before cleaning, disconnect the mains plug from the socket and allow the iron to cool down sufficiently.
1. Wipe the soleplate with a damp cloth and a non-abrasive (liquid) cleaner.
2. If fibres stick to the soleplate, use a toothpick. Do not damage the surface of the soleplate.
3. Never use strong acid or alkali to avoid damaging the soleplate.
4. If deposits are blocking the steam hole of the iron soleplate, remove them with a damp cloth and vinegar.
5. Place the iron vertically and allow it to cool sufficiently. Pour the remaining water out of the container and set the
steam selector to „no steam".
NOTE: Deposits or minerals in the water will cause scale to form and block the steam holes. It is therefore advisable to
use distilled water.
TROUBLESHOOTING
Problem
Not enough heat
No steam
No steam burst or no vertical
steam
Water is leaking from the soleplate
29899 M29898_Livington_IronFlex_Manual_20210607_DR.indd 10 29899 M29898_Livington_IronFlex_Manual_20210607_DR.indd 10
Attention Please note that the label states that this item may not be ironed
Type of fabric
Nylon
Wool/Silk
Cotton/Linen
Possible reason
Thermostat dial set too low or iron is
not connected
The thermostat dial has been set
too low.
The steam burst function is being
used very often within a short time
(iron is not hot enough).
The thermostat dial is located
outside the steam range.
Not hot enough
Possible solution
Adjust the thermostat dial or connect
the power supply.
Set the thermostat switch to the
desired position.
Continue ironing in the horizontal
position and wait a while before
using the (vertical) steam burst
function again
Set the thermostat control to the
steam range.
Only set the steam selector switch to
the steam position
after the indicator light has gone out
10
Thermostat knob
MIN
MAX
14.06.21 12:09 14.06.21 12:09