Aligning The Camera; Inital Start-Up - Abus TVIP41500 Manual De Instrucciones

7.2 Aligning the camera

First, undo the black dome cover. Loosen the screws at the side on the bracket to align the lens.
The camera can be aligned in 2 axes.
Setting the angle of rotation
Rotation: 0°–360°
Setting the angle of inclination
Inclination: 0°–65°
Do not forget to tighten up the screws again!

8. Inital start-up

The network camera automatically detects whether a direct connection between the PC and camera
should be made. A crossover network cable is not required for this.
Direct connection of the network camera to a PC/laptop
1. Ensure that a CAT 5 network cable is used.
2. Connect the cable to the Ethernet interface of the PC/laptop and the network camera.
3. Connect the power supply to the network camera.
4. Configure the network interface of your PC/laptop to the IP address 192.168.0.2 default
gateway to 192.168.0.1
5. Go to 8, to finish the initial set-up and establish the connection to the network camera.
62
English