Publicidad
Idiomas disponibles
Idiomas disponibles
Protection Against Deep Discharging
The lithium ion battery is protected against deep
discharging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the tool is
switched off by means of a protective circuit.
Depth Adjustment
Adjust the cutting depth so
that no more than one tooth
is visible below the work piece. Excessive blade
exposure below the workpiece could result in
personal injury and/or property damage.
The depth adjustment sys-
tem should not be used to
change the depth while the saw is in operation,
or for plunge cutting. If blade adjustment shifts
while cutting, it may cause binding and kick-
back.
To adjust the cutting depth follow these instruc-
tions:
A. Disconnect the Battery Pack (Fig. 1, 9) from
tool.
B. Loosen the Depth Adjustment Lock Lever
(Fig. 4, 21) located on the left side of the
tool.
C. Hold the Foot (Fig. 1, 14) down with one
hand and raise or lower saw by the Main
Handle (16).
– For a smaller cutting depth, pull the saw
away from the Foot (14);
– for a deeper cutting depth, push the saw
toward the Foot (14).
D. Tighten the depth adjustment lever at the
desired depth setting.
Note: Not more than one tooth length of the
blade should extend below the material to be
cut (Fig. 5).
Operation
Overload Protection
Your saw is equipped with Electronic Motor Pro-
tection (EMP), which shuts the tool off under
overload conditions that could damage the tool.
This feature can be reset by simply releasing the
trigger and re-engaging the trigger again to re-
start the tool.
-15-
Fig. 5
Publicidad
