universalblue UBCA2004-21 Manual De Instrucciones página 26

Regulations concerning the discharge of air have to be
fulfilled.
lnstall wall cap. Connect round metal duct to cap and work
back towards hood location. Use duct tape to seal the joints
between ductwork sections.
ELECTRICAL INSTALLATION
Electrical wiring must be done by a qualified person(s) in
accordance with all applicable cedes and standards. This range
hood must be properly grounded. Turn off electrical power at
service entrance before wiring.
lf the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
INSTALL THE HOOD
Note 1: On stainless steel hoods, carefully remove the plastic
protective
film from all exterior surfaces of the hood and chimney prior to
final installation.
Note 2: At least two people will be required to mount the hood.
When installing the hood, the minimum safety distances mentioned
above must be kept in mind.
To install the hood, please read the following installation notes
carefully:
 Attach the discharge conduit to the air outlet adapter and use
 ST3x8 screws (2) to hold both parts.
 Drill 4 holes in the wall and place the 4 plasterboard moorings
(10x45 mm). Use ST5x45 screws (2) to hold the top of the hood
26