PYD Electrobombas MP Serie Manual De Instalación Y Mantenimiento página 9

INSTRUCTIONS MANUAL AND MAINTENANCE
SERIE MP
- Avoid body contact with earthed surfaces.
- Do not abuse the cord. Never use the cord to carry, pull or unplug the pump. Keep cord away
from heat, oil, sharp edges, or moving parts. Damaged or entangled cords increase the risk of
electric shock.
- When operating a pump outdoors, use an extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
- The pump is equipped with a compatible plug. The power supply in your country must comply
with international regulations.
- If the power cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid hazards.
WARNING: Improper extension cords can be dangerous. If an extension cord is used, it must be
suitable for outdoor use and the connection must be kept dry and off the ground. It is recommen-
ded that this is done using a cable reel that keeps the plug at least 60 mm above the ground.
5. MAINTENANCE
Our pumps do not require specific maintenance, but the following operations are recommended:
- In case of temporary installation, the pump should be cleaned with clean water after use.
- In case of permanent installation, it is necessary to check every 3 months that the starting
mechanism is working properly (float switch or sensor).
- Periodically remove any dirt that may accumulate in the crankcase.
- Do not expose to frost.
- Avoid dry running.
- Do not mistreat the cable. Never use the cable to carry, pull or unplug the pump.
- Clean the pump regularly if the suctioned liquid produces sediments.
- Avoid knocks, do not drop the pump.
Impeller 3. Junction box 5. Fan cover 7. Rotor 9. Suction casing 2. Diffuser 4. Fan 6. Bearings
8. Stator winding 4. Fan 6. Bearings 10. Mechanical seal 12. Discharge plug
www.proindecsa.com / proindecsa@proindecsa.com
9