Operation; Manual-Mode; Call Up Projectors Manually; Programming - EuroLite DMX OPERATOR Manual Del Usuario

The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
You can adjust the XLR polarity via the DMX POLARITY selector.
Building a serial DMX-chain:
Connect the DMX-output of the DMX Operator with the DMX-input of the nearest projector. Always connect
one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Projector addressing
Please note that the DMX Operator assigns the DMX-starting addresses every 16 steps. You have to
address every projector to the respective starting address. Otherwise, the channel assignment will not be
correct. All projectors with the same starting address work synchronically.
Projector Starting address
Projector 1 1
Projector 2 17
Projector 7 97
Projector 10 145

6. OPERATION

After you connected the device to the mains, the DMX Operator is ready for use.

6.1 Manual-mode

6.1.1 Call up projectors manually

In the Manual-mode (Program-LED off), you can call up the connected projectors manually and control them
via the channel faders. Please note that the adjusted settings cannot me memorized.
Select the desired projector via the respective projector select button.
Adust the desired function via the channel faders.
Page Select-button:
Via the Page Select-button, you can adjust the channel faders from CH 1-8 to CH 9-16.
Display-button:
Via the Display-button, you can switch the display of the faderway from DMX-value (0-255) to procent (0-
100).

6.2 Programming

A program is a sequence of different scenes that will be called up one after another. With the DMX Operator,
you can program up to 30 different programs (banks) with up to 8 scenes each.

6.2.1 Programming a program

Press and hold the Program-button until the Program-LED flashes in the display. Select the desired program
(bank) via the Bank-buttons.
the fixtures will not work at all, or will not work properly.
Projector
Projector 3
Projector 4
Projector 8
Projector 11
Starting address Projector
33 Projector 5
49 Projector 6
113 Projector 9
161 Projector 12
18/41
Ω
resistor
Starting address
65
81
129
177
70064520_V_2_0.DOC