Publicidad
Idiomas disponibles
Idiomas disponibles
Hot Surface Warning!
The Side wall of your product is
equipped with refrigerant pipes to
improve
Refrigerant with high temperature
may
flow
resulting in hot surfaces on the side wall
this is normal and does not need any
servicing. Please, pay attention while
touching these areas.
4
Preparation
• Your cooler/freezer should be installed at least 11.5in away from
heat sources such as cooktops, ovens, central heaters, and
stoves and at least 5 cm away from electrical ovens and should not
be located under direct sunlight.
• Please make sure that the interior of your cooler/freezer is
cleaned thoroughly.
• If two coolers are to be installed side by side, there should
be at least a 2 cm distance between them.
• When you operate your cooler/freezer for the first time, please
observe the following instructions during the initial hours:
• Door should not be opened frequently.
• It must be operated empty without placing any food in it.
• Do not unplug your cooler/freezer. If a power failure occurs
out of your control, please see the warnings in the
"Recommended solutions for the problems" section.
• The baskets/drawers that are provided with the chill
compartment must always be in use for low energy
consumption and for better storage conditions.
• Food contact with the temperature sensor in the freezer
compartment may increase the energy consumption of the
appliance. Thus, any contact with the sensor(s) must be
avoided.
In some models, the instrument panel automatically turns off
5 minutes after the door has closed. It will be reactivated when
the door has opened or pressed any key.
• As a result of opening/closing the unit's door during
operation, condensation inside the unit is normal.
9
the
cooling
system.
through
these
areas,
Using Your Refrigerator
5
Indicator panel (Internal Display) *
Indicator panels may vary according to the product
model. Audiovisual functions on the indicator panel help
you in using your product.
1
8
*optional
1. Freezer compartment indicator
The refrigerator compartment light is illuminated while the
freezer compartment temperature is set.
2. Error status indicator
If your unit is not cool enough or there is a fault in the
sensor, this indicator is activated. When this indicator is
activated, "E" is displayed on the freezer compartment
temperature indicator, and numbers such as "1,2,3." are
displayed on the refrigerator compartment
temperature indicator. These numbers on the indicator inform
service personnel about the error.
3. Temperature indicator
Indicates freezer, refrigerator compartment temperature.
4. Vacation function button
Press on Vacation Button for 3 seconds to activate this
function. When the vacation function is activated, "- -" is
displayed on the refrigerator compartment temperature
indicator, and no active cooling is performed on the
refrigerator compartment. It is not suitable to keep the food in
the refrigerator compartment when this function is
activated.
Other compartments shall be continued to be cooled as
per their set temperature. To cancel this function, press
the Vacation button again.
5. Temperature setting button
Changes the temperature of the relevant compartment
between -24°C-18°C (-11.2°F -0.4°F) and 8°C-1°C
(46.4°F - 33.8°F)
6. Compartment selection button
Selection button: Press the compartment selection button to
switch between the refrigerator and freezer compartments.
7. Refrigerator compartment indicator
Refrigerator compartment light is illuminated while the
refrigerator compartment temperature is set.
8. Economy mode indicator
Indicates that the refrigerator operates in energy saving
model. This display shall be activated if the freezer
compartment temperature is set to -18°C (0.4°F).
9. Vacation function indicator
Indicates that vacation is activated.
10. Icematic function (optional)
Indicates whether the icematic is on or off. (
then the icematic is not operating. To operate the icematic
again, press and hold the On-Off button for 3 seconds.
6
2
3
6 10*
7
5
4
) If off,
Publicidad
