GYS DUST SELF EXTRACTOR Manual De Instrucciones página 12

Operating manual
REGULATION
• The device complies with the European directives.
• The declaration of conformity is available on our website.
• EAC (Eurasian Economic Community) mark of conformity
• Material conforms to UK requirements.
• The UK Declaration of Conformity is available on our website (see cover page).
WASTE DISPOSAL
• This material is subject to separate collection. Do not dispose of in domestic waste.
EN 60335-2-69
The dust compartment should be emptied as necessary, but also after each use.
Type 22 units are not suitable for the extraction of dusts or liquids with a high explosion risk, or mix-
tures of combustible dusts and liquids.
CAUTION - Use only accessories approved by the manufacturer for use with the Type 22. Use of
other accessories may cause an explosion hazard.
CAUTION - Use only accessories approved for use with the Type ESD protected area. Use of other
accessories may cause electrostatic discharge.
EN 60335-2-69
The appliance should only be operated when all filters, including the engine cooling air filters, are in
place and undamaged.
Dust extractors of the ESD protected area type are suitable for connection to dust producing devices
in ESD protected areas. It must be ensured that no sources of ignition are drawn in. Conductive parts
of appliances, including extractor hoods and conductive parts of Class II appliances, must be elec-
trostatically grounded. Electrostatic earthing may be achieved through the dust extractor or through
an independent electrostatic earthing device.
Type 1 and Type Zone electrostatically protected dust extractors are not suitable for use in equipment
in which ignition sources are produced.
PNEUMATICS
The inlet air system pressure must be less than or equal to 10 bar.
A higher pneumatic pressure than recommended can alter the operation of the product, with a signifi-
cant loss of suction. In this case, it is necessary to check the pressure at the product inlet and on the
suction system, located inside the product. (Setting 4 bars max).
A malfunction of the suction system can occur when the bag is full or completely blocked. In this case,
the full bag must be removed and replaced by a new one. For the bag, the manufacturer's recommen-
dations must be followed. Dry and filtered air supply.
12
Translation of the original
instructions
GYSDUST SELF EXTRACTOR