Kärcher WD 5 P Instrucciones De Operación página 9

Note
For convenient vacuuming in confined
spaces, the handle can be removed
and the accessory attached directly to
the suction hose.
To release the handle, press the gray
areas on both sides of the handle and
pull the handle off the hose.
3. Connect the floor nozzle to the suc-
tion tubes.
 Use the position with the brush
strips extended to vacuum dry dirt.
 Use the position with squeegees ex-
tended to suck up damp dirt / water.
Starting up the device
1. Plug the power plug into a electrical
outlet.
2. Set the power switch to the desired
position.
 "MAX" position: The suction /
blower function is activated.
 MAX position
activated automatically when a
power tool is connected.
 Position "0 OFF": The device is
switched off.
Note
As long as the device is supplied with
power, the device socket can be used
as a power source.
ATTENTION
Missing flat pleated filter
Device damage
Always work with the flat pleated filter
inserted.
Note
When purchasing and installing filter
bags and flat pleated filters, pay atten-
tion to the current part numbers.
Information on accessories and spare
parts can be found at 
www.kaercher.com.
Dry vacuuming
ATTENTION
Sucking cold ashes
Device damage
Only vacuum cold ash with an ash pre-
separator.
ATTENTION
Defective or wet flat pleated filter
Device damage
Before using, check the flat pleated fil-
ter for damage and replace it if neces-
sary.
Only vacuum with a dry flat pleated fil-
ter.
English
: The suction is
Operation
9