Publicidad
Idiomas disponibles
Idiomas disponibles
•
Firmly screw the oil cap.
To check the correct operation of the oil pump, turn on the chainsaw and check if there are traces of oil
on the ground below.
If there is no trace of oild, check that the tank has been filled correctly.
If there are no traces of oil with the tank full, contact the Service Center.
Warning!
Do not use the chainsaw if the oil pump is not working properly.
Keep the chain Sharp. Contact the Service Center for this operation.
The chainsaw has a nozzle for periodic lubrication of the gearbox:
•
Every 40 hours of actual accumulated work (see display), it is necessary to add a small amount of
consistency 1 lithium grease to the gearbox.
•
Use a damp cloth to clean around the nozzle.
•
Turn the brass cover counterclockwise and remove it before adding lubricant.
•
Using the supplied injector, place the grease inside and screw it onto the nozzle by turning
clockwise.
•
Push in the injector and add about 5-10 g of grease.
•
Unscrew the injector from the nozzle, close and tighten the grease cap on the machine.
•
If you have the KV grease ref.14360, you can use it by executing points 1, 2 and 3, then insert the
nozzle of the grease bottle into the grease nozzle of the machine, press for 1 second and insert a
small amount of grease inside, remove the can from inside the machine and wait 2 minutes for the
gases inside the reducer to come out through the nozzle of the machine. Then close and tighten
the greasing cap of the machine.
45
Publicidad
