Publicidad
Idiomas disponibles
Idiomas disponibles
from the mains inmmediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
- Do not carry the machine by the
cable.
- Disconnect the machine from the
mains supply
•whenever you leave the machine,
•before clearing a blockage,
•before checking, cleaning or
working on the machine,
•if the machine starts to vibrate
abnormaly.
- Operate the machine only in
daylight or in good artificial light.
- Do not overreach and keep your
balance at all times.
- Always be sure of your footing on
slopes.
- Walk, never run,
- Keep all cooling air inlets clear of
debris.
-Never blow debris in the direction
of bystanders.
- Recommendation to operate the
machine only at reasonable hours
-not early in the morning or late
at night when people might be
disturbed.
- Recommendation to use rakes
and brooms to loosen debris before
blowing/ vacuuming;
-
Recommendation
dampen surfaces in dusty conditions
or use mister attachment;
-Recommendaion to use the full
blower nozzle extension so the air
stream can work close to the ground.
4) Maintenance and storage
- Keep all nuts, bolts and screws
tight to be sure the machine is in
safe working condiiton.
-
Check
the
frequently for wear or deterioration.
- Replace worn or damaged parts.
- Use only genuine replacement
parts and PROMAKER
- Store the machine only in a dry
place.
Recommendations:
- To connect the machine only to a
supply circuit protected by a residual
current devide (RCD) with a tripping
current of not more than 30 mA for
mains powered machines.
- To avoid using the machine in bad
weather conditions especially when
there is a risk of lighting.
Supply cors shall not be lighter than:
- If rubber insulated, ordinary tough
to
slightly
debris
collector
accesories.
®
3
Publicidad
