Publicidad
Idiomas disponibles
Idiomas disponibles
in the opposite direction.
Mounting The Nozzle And Dust
For Dust Collection (fig. B)
· For dust collection, mount the Dust
Bag at the Blast Port (2) and Nozzle
at the suction Port (6).
· To remove Dust Beg and Nozzle,
simply pull out by first turning in the
opposite direction.
· Empty the Dust Bag frequently to
ensure maximum dust collecting
efficiency.
· Adjust Variable Speed Knob (4)
marked
with
different speed requirement.
· When continuous operation is
required, first depress the switch
and then the lock-on button (5) and
release to disengage lock, squeeze
and release switch.
Warning: Continuous running of
machine should not exceed 30
minutes.
Replacing Carbon Brushes (fig.
D)
· Use a screwdriver to remove the
brush holder cap.
· Take out the worn carbon brush,
insert the new one and secure the
brush hold cap.
Warning! Remove and check the
carbon brushes regularly. Replace
when they wear down to the limit
mark.
Accessories
The performance of your tool
depends on the accessory used.
"MIN"&
"MAX"for
Manufacture and accessories are
engineered to high quality standards
and
designed
performance of your tool. By using
these accessories you will get the very
best from your PROMAKER
Maintenance
Your tool has been designed to
operate over a long period of time
with a minimum of maintenance.
Continuous satisfactory operation
depends upon proper tool care and
regular cleaning.
Warning! Before performing any
maintenance, switch off and unplug
the tool.
· Regularly clean the ventilation
slots in your tool using a soft brush
or dry cloth.
· Regularly clean the motor housing
using a damp cloth. Do not use any
abrasive or solvent-based cleaner.
Technical Specifications
Voltage/
Frequency
Power
Speed
Air volumen
Weight
Cord
to
enhance
tool.
®
220V/
50Hz
400W
6000-14000rpm
3.3m
/ min
3
3.19Lbs
2m
the
7
Publicidad
