EN Care & maintenance
IMPORTANT: Switch off the electrical supply at the consumer unit before
replacing the carbon filters.
01 Carbon filter replacement
Replace every three months.
3 MONTHS
2 x Carbon filter, model number CARBFILT4 3663602843092 available via the customer helpline - see end
of Care & maintenance section for details.
If the motor is off, and after the fan has been in operation for approximately 150 hours, the display will show
and the Timer will flash red to advise you to replace the carbon filters. After replacing the filters, reset the
alert by pressing the Timer
WARNING: Always switch off the electrical supply before carrying out
maintenance work on the hood. In the event of a fault, contact customer
services.
02 Aluminum grease filter cleaning
Aluminium filters: To avoid fires, clean thoroughly once a month. Remove the grease filter as shown and
soak in hot water and detergent for an hour. If using a dishwasher position the filters vertically to improve the
cleaning process.
1 MONTH
If the motor is off, and after the fan has been in operation for approximately 50 hours, the display will show
and the Timer will flash red to advise you to clean the aluminum grease filters. After cleaning the filters,
reset the alert by pressing the Timer
WARNING: Increase the filter cleaning/replacement frequency if the hood
is used for more than 2 hours a day. Always use genuine filters from the
manufacturer.
5059340445991_MNL_IN_V03.indb 99
5059340445991_MNL_IN_V03.indb 99
icon.
icon.
99
≤65 °C
06-06-2022 15:34:11
06-06-2022 15:34:11