Kingfisher CLAG60ASBL Manual De Instrucciones página 74

Problem
Suction performance
reduced.
Works normally
but cooking smells
linger.
Display shows "EC".
Display shows "ES".
This appliance respects laws of the suppression of radio interference. As the Manufacturer has a policy of
continuous product improvement, it reserves the right to adapt and carry out any modification considered
necessary without prior warning.
5059340445991_MNL_IN_V03.indb 73 5059340445991_MNL_IN_V03.indb 73
Possible cause
Speed may be too low.
Aluminium filters are dirty.
Top vent might be obstructed.
Optional vent kit might be twisted.
The installation may not comply with
the manufacturers instructions.
Carbon filter is not fitted in
recirculation mode or is full of grease.
Calibration error.
Sensor error.
Solution
Select a higher speed.
Clean the aluminium filters. (See Care and
maintenance section).
Clear any obstruction.
Ensure that the vent kit is fitted according
to the manufacturer's instructions.
The vent hose should be correct diameter
throughout with no reductions or
restriction. (See installation section).
Fit carbon filter or replace the carbon filter
(See Care and maintenance section).
Run the calibration procedure again, (see
Control panel and set up).
If this does not rectify the error, call the
customer helpline at the end of the Care
and maintenance section.
Note: The hood will still operate in manual
mode.
Turn off the power supply at the consumer
unit. Wait for two minutes and turn the
power back on.
Run the calibration procedure again, (see
Control panel and set up).
If this does not rectify the error, call the
customer helpline at the end of the Care
and maintenance section.
Note: The hood will still operate in manual
mode.
73
06-06-2022 15:34:08 06-06-2022 15:34:08