Descargar Imprimir esta página

Ryobi PTS01 Manual Del Operador página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

Look for these accessories where you purchased this product or call 1-800-525-2579:
 27.5 in. Track Assembly (incl. two connectors, set screws, and rubber cut strips) ....................................089240074701
 55 in. Track Assembly (incl. two connectors, set screws, and rubber cut strips) .......................................089240074710
 Track Connector Assembly (incl. two connectors and set screws) .............................................................089240074711
 Riving Knife ..................................................................................................................................................089240074115
 27.5 in. Rubber Cut Strip .............................................................................................................................089240074117
 55 in. Rubber Cut Strip ................................................................................................................................089240074116
 Track Adjustment Tabs ...........................................................................089240074118 (front) and 089240074119 (back)
 6-1/2 in. Blade .............................................................................................................................................089240074110
 Track Clamp Assembly ................................................................................................................................089240074712
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not rec-
ommended can result in serious personal injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the product when cleaning or perform-
ing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
NOTE: ILLUSTRATIONS START ON PAGE 17 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
ACCESSORIES
MAINTENANCE
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
REPLACING THE TRACK ADJUSTMENT TAB
See Figure 46, page 25.
After extended use, the track adjustment tab may wear and
need replacing. To replace the tab:
 Remove the battery pack from the saw.
 Remove the saw from the track.
 Loosen and remove the lock knob.
 Remove the washer and the track adjustment tab.
 Place the new track adjustment tab over the hole in the
base.
NOTE: There are track adjustment tabs in the front and
back of the saw. These tabs are not interchangeable.
Always use identical replacement parts.
 Secure the tab in place using the washer and lock knob.
 Place the saw onto the track and adjust the tabs as nec-
essary.
16 - English

Publicidad

loading