Publicidad
Idiomas disponibles
Idiomas disponibles
EN
BALANCE UNIT
1. Put on strap and attach unit to
strap.
2. Depending on the working
posture, slide clamp up or down
until unit balances and the strap fits
your body.
ATTACHING THE PRUNING
MECHANISM
1) Main pipe
(2) Transmission
(3) Screw hole
(4) Fastening bolt
(5) Bolt
1. Remove the cap on the end of the
main pipe.
2. Remove the screw screwed into
the end of the transmission.
3. Insert the end of the gear case
into the main pipe.
4. Line up the hole on the end of the
transmission into which the screw
is to be inserted with the hole on
the main pipe, and screw the screw
firmly in.
5. Using a wrench, screw in the bolt
provided to fix the mechanism into
place.
A standard package contains the
items as shown below.
48
1) Guide bar
(2) Saw chain
(3) Transmission
(4) Sprocket
(5) Chain tension adjust screw
(6) Nut
(7) Chain tensioner nut
(8) Chain cover
Install the guide bar and the saw
chain on the transmission as
follows.
WARNING
The saw chain has very sharp
edges. Use protective gloves for
safety.
1. Loosen a nut and remove the
chain cover.
2. Mount the guide bar then fit
the saw chain around the bar and
sprocket.
WARNING
Pay attention to the correct
direction of the saw chain.
3. Fit the chain tensioner nut into
the lower hole of the guide bar, then
install the chain cover, and fasten
the mounting nut to finger tightness
(1) Hole
(2) Moving direction
(3) Chain tensioner nut
4. Adjust the chain tension by
turning the tensioner screw until the
tie straps just touch the bottom side
of the bar rail.
(1) Chain tension adjusting screw
(a) Loosen (b) Tighten
5. Tighten the mounting nut
securely with the bar tip held up
(TORQUE: 8.9 - 11.7 N.m./90 -
120 kg-cm). Then check the chain
for smooth rotation and correct
ten-sion while moving it by hand. If
necessary, readjust.
WARNING
It is very important to maintain
the proper chain tension.
Especially when using a new
chain, take good care of it since it
should expand when first used.
Publicidad
