Samsung DW60A807 Serie Manual Del Usuario página 309

Before you start
Rinse aid level setting
You can change the amount of rinse aid applied during a cycle.
1. To select the rinse aid level setting menu. Select the "AUTO" key for 5 seconds, after the
beep followed by the reset of the "0:00" display, press the "Sanitize" key.
- The display shows the current setting. (Default setting: "F4")
2. Press the AUTO cycle button to change the setting.
- You can select from F1 - F5 (minimum – maximum).
3. Wait 5 seconds to save the setting.
Water hardness level setting
You can change the water hardness level according to water hardness in your local area.
Changing this setting will have effect on the salt consumption in the dishwasher's salt
storage.
1. To select the water hardness level setting menu. Select the "AUTO" button for 5 seconds,
after the beep followed by the display reset: "0:00", press the "Delay Start" button.
- The display shows the current setting. (Default setting: "H3")
2. Press the AUTO cycle button to change the setting.
- You can select from H1 – H6 (soft – hard).
3. Wait 5 seconds to save the setting.
NOTE
• Change the setting according to the table in the "Adjusting salt consumption" section on
page 62.
• Default Setting: H3
• The dishwasher regenerates the water softener once every 3–4 cycles depending on the
setting. However, the dishwasher will regenerate the water softener on the first cycle
after you change the setting.
56 English
DW8500AM_DW60A8070BB_EF_DD81-03206D-01_FR+ES+PT+EN.indb 56 DW8500AM_DW60A8070BB_EF_DD81-03206D-01_FR+ES+PT+EN.indb 56 2021-03-24 2021-03-24 12:44:26 12:44:26