Siemens TB 15 Serie Instrucciones De Uso página 4

en
This appliance is intended for domestic and not
industrial use.
Keep the operating instructions in a safe place!
Safety information
A A Electric shock and fire risk
Connect and operate the appliance only in accordance
with the specifications on the rating plate.
lf the cable or appliance is damaged, do NOT use the
appliance.
Keep children away from the appliance.
After using the appliance and if a fault occurs,
pull out the plug.
Before filling the tank, pull out the plug. For safety rea-
sons, repairs e.g. replacing a damaged cable, should
only be carried out by our Customer service division.
NEVER leave a switched-on iron unattended!
Before using your appliance for the
first time
Take the protector off the sole plate
Allow tap water to evaporate for 10 to
20 seconds (press the motor steam button, Fig. 4).
Using the appliance
The pilot light switches ON while the appliance is hea-
ting up and switches OFF as soon as the set tempera-
ture is reached. lf the temperature of the hot iron
drops, you can continue ironing while the iron heats up
again to the set temperature.
Sort laundry according to the fabric care labels and
start at the lowest temperature
Ironing without steam
Do NOT press the motor steam button.
Filling the tank
First remove the plug!
Use only clean water from the tap without mixing
anything with it. The addition of other liquids will
damage the appliance.
Mix tap water with distilled water according to the
following table in order to prolong the optimum
stream function.
Water Ratio of distilled water
hardness To tap water
Very soft/soft
Medium
Hard
Very hard
You can inquire about the water hardness with
your local waterworks.
Do not fill beyond the "Max." level mark!
:
Fig.2/3
0
0
approx. 1
approx. 2
Ironing with steam
The motor conveys a uniform volume of steam.
lf the set temperature is too low, the steam is
automatically switched off to prevent dripping.
Steam volume control
(for some models)
Your ¡ron is equipped with steam volume control.
Use the control dial to set the steam volume;
Dial to the left
Dial to the right
The steam volume control is lighted.
Spray
Vertical steam feature
Temperature: max
Hang a item of clothing on a hanger and move
the ¡ron vertically at a distance of 10-20 cm from the
clothing, holding down the motor steam
button.
Do NOT iron clothing which is being worn!
After ironing
Empty the tank: hold the ¡ron with the point down
and shake gently.
Store the ¡ron upright and not on the soleplate.
Risk of corrosion (Fig. 8)!
Cleaning
Pull out the mains plug and allow the soleplate to
cool down.
Wipe the housing and soleplate with a damp
cloth only. lf the soleplate is very dirty, iron a linen
cloth soaked in white vinegar or place the
Fig.1
soleplate in a receptacle containing vinegar (max.
1 mm deep). Then rinse with water and dry
thoroughly. Or:
At max setting rub off residue immediately with
a thickly folded, dry cotton cloth.
A A Caution! Risk of burns!
Never descale the tank or treat with
detergents or solvents, as this would cause
water to drip from the iron when generating
or spraying steam!
Instead: approx. every 4 weeks heat up the ¡ron
with a full tank for 3 minutes at max. setting, then
switch to min. setting and hold the ¡ron over
a bowl and press the motor steam button (Fig. 4)
until the motor automatically switches off
(recognisable by noise and vibration). Set to max.
again and press the motor steam button for
2-3 minutes to flush out the steam chamber.
When the soleplate has cooled down, clean
thoroughly with a damp cloth.
Do not clean the appliance with a professional
steam cleaner
Disposal
Please ask your dealer or inquire at your local
authority about current means of disposal.
minimum steam volume
=
maximum steam volume
=
Fig. 4
Fig. 5
Fig.6
Fig.7
3