Franke ZAQUA091 Instrucciones De Montaje Y Uso página 10

Resetting default factory settings (Reset)
9.24 Press the RESET key for at least 3 s.
• The system now has the factory settings again.
• The LED in the sensor of the fitting flashes:
– 4 × short, 3 × short, 3 x short
Changing the type of detection (only for on-wall washbasin mixer installation)
Water flow should start/stop when a hand approaches/moves away from the
sensor (3-7 cm).
9.25 Press the "
• The LED in the sensor of the fitting flashes:
– 2 × long
9.26 Press the "
• The type of detection has been changed. The sensor only responds when a hand
approaches/moves away. The range can be adjusted (see
• The LED in the sensor of the fitting flashes:
– 5 × long, 3 × short
Water flow should start/stop when a person approaches/moves away from the
sensor (>35 cm).
9.27 Press the "
• The LED in the sensor of the fitting flashes:
– 2 × long
9.28 Press the "
• The type of detection has been changed. The sensor only responds when a
person approaches/moves away. The range can be adjusted (see
• The LED in the sensor of the fitting flashes:
– 5 × long, 3 × short
Resetting the type of detection to the default factory setting
9.29 Press the RESET key.
10
–" key repeatedly until the minimum sensor range is reached.
–" key again.
+" key repeatedly until the maximum sensor range is reached.
+" key again.
chapter 8.).
chapter 8.).