Chamberlain Bilt C2212T Manual De Instalación página 47

Routine Maintenance Can Prevent Tragedies
Make monthly inspection and testing of your garage door and opener system a part of your regular routine. Review your owner's manual for both the door and door opener. If you don't have the
owner's manuals, contact the manufacturer(s) and request a copy for your specific model(s). Look for the opener model number on the back of the power unit.
WARNING – SPRINGS ARE UNDER HIGH TENSION. ONLY QUALIFIED INDIVIDUALS SHOULD ADJUST THEM.
2
1
Visually check the door and installation:
Starting with the door in the closed position, use the manual disconnect on the opener to disconnect the door.

Look for signs of wear or damage on hinges, rollers, springs, and door panels.

These parts may require periodic lubrication. Check the owner's manual for suggested maintenance.

If any signs of damage are evident, contact a trained door systems technician for assistance.

Verify the photo eye height is no higher than 6" from the garage floor.

Test the door for proper operation:
Open and close the door manually using handles or suitable gripping points.

The door should move freely and without difficulty.

The door should balance and stay partially open 3–4 feet above the floor.

If you detect any signs of improper operation, contact a trained door systems technician for assistance.

Test the opener safety features:
Reconnect the opener to the door using the manual disconnect and open the door.

Place a 2x4 board flat in the path of the door (1) and try to close it (2). The door should stop when it comes

in contact with the 2x4 and then reverse direction.
Block the photoelectric sensor by waving an object in front of the sensor and attempt to close the door. The

door should not close unless the wall-mounted push button is manually held during operation.
If the opener does not perform as described, contact a trained door systems technician for assistance.

47