The flashing light indicates when you should replace the filter:
Green:
The water filter is filtering optimally.
Yellow: It will soon be time to change the water filter. Think about
purchasing a new one!
Red:
Please change the water filter!
You can check your filter status at any time by pressing briefly on
the BRITA Smart Light.
BRITA Memo J K
Remove the protective foil before using BRITA Memo for the first
time.
After activating the water filter, press and hold the „START" button
until four bars appear on the display and flash twice.
The flashing dot in the bottom right of the display unit means:
"Memo in operation".
A new water filter is required if the empty display unit flashes.
Changing the MAXTRA PRO water filter L
7
Simply remove the water filter and follow steps 1 to 6 of the
instructions.
Important information
Never place the BRITA water filter jug and the MAXTRA PRO
water filter in full sun and keep away from heating elements
(e.g. kettles or conventional ovens).
It is better to store them in a dark, cool and dry place (and keep
new water filters in their original packaging). Store the BRITA
Smart Light out of the reach of children (risk of swallowing)!
Sensitive to potassium?
Filtering initially causes a slight elevation in the potassium content
of the water. This is harmless (e.g. 1 L of BRITA filtered water
contains less potassium than an apple).
Please consult your doctor before using a BRITA water filter if
you suffer from kidney disease or have to follow a special low-
potassium diet.
Natural traces
The BRITA activated carbon beads are of natural origin and so
natural variations may occur.
A low volume of small carbon particles can get into the filtered
water, which you may see as black particles.
These particles are not harmful to your health because they pass
naturally through the body unchanged if swallowed.
If you discover carbon particles in your filtered water, BRITA
recommends rinsing the water filter until there are no more
particles visible.