JBL 4329P Manual Del Propietário página 3

4. General Placement / Set-up
Room Placement
In a traditional set-up, position each speaker in a vertical orientation with the tweeter on the
top. The speakers should be placed so the listening position and the two speakers form an
equilateral triangle. Depending on the size of the room and the distance between speakers this
correlates to between a 10 to 25 degree "toe-in" into the center of the room.
On the back of the Primary speaker, set the bass contour switch based on the speaker's
proximity to side boundaries such as walls, inside a bookcase / cabinet, or on floor stands.
Recommended Bass Contour settings
When positioned away from side boundaries or on a stand set to 0dB.
When positioned close to side boundaries or when the speaker is inside of a cabinet or
bookcase set to -3dB.
On the back of the Primary speaker, set the L/R Assign switch to identify the Primary speaker
based on your selected positioning.
Speaker System Set-up
1. Make sure AC Main switch is set to Off.
2. Connect the provided AC cords between the AC Inlets on the back of both speakers and the other end to your home AC outlet.
3. Connecting the Primary Speaker to the Secondary Speaker:
a. Hardwired: Attach one end of the supplied CAT5e cable to the Digital Link connector on the back of the Primary speaker and
the other end to the Digital Link connector on the back of the Secondary speaker. Maximum CAT5e cable length 20' (6m).
This will deliver the highest level of audio quality at 192kHz / 32bit between the two speakers. Both speakers Power LEDs will
illuminate solid White when tethered together.
b. Wireless: Each pair of 4329P have been pre-associated for wireless connectivity at the factory. Maximum distance between
speaker should be 30' (9m) or less. Maximum audio quality through wireless connection is 96kHz / 24bit. Both speakers
Power LEDs will illuminate solid Green when connected wirelessly.
Wireless Note: If for some reason the speakers in this system become un-associated from each other follow the
i.
following steps:
1. Verify both speakers are On.
2. On the back of the Secondary speaker, Press and Hold the Sync button for >3 seconds. The Power LED will
illuminate and flash Yellow color.
3. On the back of the Primary speaker, Press and Hold the Sync button for >3 seconds. The Power LED will illuminate
and flash Yellow color.
4. When association is successfully completed, both Primary and Secondary speaker Power LEDs will Illuminate solid
Green.
4. Turn the volume down located on the Primary speaker.
5. Set the AC main switch on the back of both speakers to On.
Note: When powered up, the system will boot-up, indicated by all LEDs on the front panels flashing White. Once the boot-up process
is completed, the system automatically enters an initial network setup mode.
4329P OM | Part No: 950-0628-001 | Rev 1.0 20221201
© 2023 HARMAN International Industries. Incorporated All rights reserved.
EN
BASS
CONTOUR
-3dB 0dB
BASS
CONTOUR
-3dB
0dB
L/R
ASSIGN
L
R
Pg 3 of 11