Replacing The Grinding Disc; Switching On/Off; Care And Maintenance - EDM 08752 Manual De Instrucciones

Cordless angle grinder
Operating Instructions
• Pull the quick clamping head
• Turn the guard to the desired position
• Press the quick clamping head

Replacing the grinding disc

WARNING: Beware that a disc which has been used may be
very hot!
• Depress and hold down the spindle lock button to secure
the spindle.
• Turn the shaft until it locks.
• Remove the outer flange and backing flange by using the
two-hole spanner provided.
• Fit the desired disc on the spindle and replace the outer
flange and backing flange. Release the spindle lock.
WARNING: Important! Only ever press the spindle lock when
the motor and grinding spindle are at a standstill!
You must keep the spindle lock pressed while you change
the wheel!
For grinding wheels up to approx. 3 mm thick, screw on the
flange nut with the flat side facing the grinding wheel.

Switching On/Off

WARNING! Before engage on the ON/OFF switch button,
check that the grinding disc is properly fitted and run
smoothly, the outer flange is well tightened.
• Connect the battery pack onto the angle grinder body.
• The machine can only be started by depressing the on/off
switch left, then push the switch up, you can start the
machine.
• Press down the front part of the switch, the on/off switch
can be locked in on position (1 position) for continuous
grinding.
• Press rear part of the switch, the tool will turns off.
• Do not let go of grinder until it has stopped running.
WARNING! The wheel continues to rotate after the tool is
switched off.
Grinding
Hold the handle and auxiliary handle firmly and switch on.
Avoid blocking the ventilation slots with your hand, as this
may cause the grinder to overheat.
Let the disc reach full speed. Apply the grinder to the item.
Maximum effect is achieved when the grinder is held at an
angle of 15-30°in relation to the item.
Environmental Protection
This product is marked with the selective sorting symbol on waste electrical and electronic equipment. This means that
this product should not be disposed of with household waste but must be supported by a collection system in
accordance with Directive 2012/19/UE. It will then be recycled or dismantled to minimize impacts on the environment,
electrical and electronic products are potentially hazardous to the environment and human health due to the presence
of hazardous substances.
EN INSTRUCTION MANUAL
Move the grinder gently along the item. Give the grinder time
to work. It is rarely necessary to press the disc hard against
the surface to be worked. Sparks can occur in the motor
compartment during use. This is normal and does not mean
the grinder is defective.
Switch off the grinder after use.
Flange arrangements
Flange arrangements when using a depressed centre or
straight grinding wheel.

Care and Maintenance

Keep the ventilation openings clear and clean the product
regularly. This machine requires no special mechanical
maintenance such as greasing the bearings.
If something unusual occurs during use, switch off the supply
and remove the battery pack. Inspect and repair the tool
before using it again. The repairs must be carried out by a
qualified technician.
Repair of the tool must only be carried out by a qualified
repair technician.
Repair or maintenance by unqualified personnel can lead to
a risk of injury.
Use only identical spare parts for repairing a tool.
Caution! If there's any defective found of the battery pack, it
must be repaired or replaced by the
assigned service organization.
Care and cleaning
Cleaning of plastic parts is disconnected machines, using a
soft damp cloth and a mild soap.
Never immerse the machine and do not use detergent,
alcohol, petrol, etc..
In case of problems or for a deep cleaning, consult the
manufacturer, its service agent or a similarly qualified person
to avoid a hazard.
REF. 08752