Dremel US40 Instrucciones De Funcionamiento Y Seguridad página 10

2610049815 09-07-2017.qxp_US40 9/7/17 11:06 AM Page 10
making any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
The Lock Bolt which attaches the cutting wheel
to the tool should be turned CLOCKWISE to
be loosened and COUNTERCLOCKWISE to
be tightened (Fig. 3). This bolt is reverse
threaded compared to standard threaded
fasteners.
The Dremel Ultra-Saw features two cutting
wheel positions - one position using a standard
flat wheel for all your typical straight and
plunge cuts (Fig. 4), and a second optional
wheel position for making flush cuts along
flooring or against a wall (Fig. 5).
the tool at the same time.
Spindle Lock
Inner
Washer
FIG. 2
Standard
Flat Wheel
FIG. 4
Assembly
Disconnect the plug from
the power source before
Do not attempt to mount
two cutting wheels onto
Outer Washer
Guard Face
Standard Wheel
CUTTING WHEEL ASSEMBLY
1. Turn LOCK BOLT with wrench provided
clockwise and remove LOCK BOLT and
OUTER WASHER (Fig. 2). If the shaft
moves while attempting to loosen the lock
bolt press the spindle lock (Fig. 2).
2. Standard Flat Wheel Assembly: Slide flat
wheel behind the guard face and mount it
against the INNER WASHER on the shaft
(Fig. 4).
Flush Cutting Wheel Assembly: Place
flush cutting wheel against the INNER
WASHER on the spindle shaft. (Fig. 5).
3. Reinstall OUTER WASHER and tighten lock
bolt finger tight.
4. Press spindle lock to lock shaft and tighten
LOCK BOLT counter-clockwise until tight
with the wrench provided.
Guard Face
Flush Cutting
Wheel
(Optional)
Lock
Bolt
FIG. 5
-10-
FIG. 3
TIGHTEN
LOOSEN
LOCK BOLT
Wrench
Flush Cutting
Wheel