Vestergaard LIFESTRAW MAX Manual Del Usuario página 11

If your water is clear, we recommend cleaning the pre-filter weekly with regular
use. If your water is cloudy, you may need to clean the pre-filter more frequently.
1
MAKE SURE WATER SOURCE IS TURNED OFF.
2
SET DIALS.
gray backwash dial to position 1
REMOVE PRE-FILTER LID AND PULL OUT PRE-FILTER
3
Twist off blue pre-filter lid and take
out the pre-filter inside by pulling up
vertically.
NOTE: If is not required to remove the top lid in order
to pull out the pre-filter. However, If you have difficulty
removing the pre-filter while the top lid is closed,
slide the lid locks inward to remove the top lid before
twisting off the blue pre-filter lid.
DISASSEMBLE PRE-FILTER
4
Unscrew the black pre-filter cap
to access the 3 internal mesh pre-
filters that are stacked inside of one
another.
CLEAN PRE-FILTER
5
Using a soft plastic bristle brush, clean all parts with water. DO NOT USE
SOAP, as this could clog the pre-filter.
6
REASSEMBLE PRE-FILTER
Reassemble the 3 mesh pre-filters by placing all of the filters inside one
another and screwing back on the black cap. Insert it back into the blue
pre-filter housing by pushing downward until the bottom is in place and
tightly screwing on the light blue pre-filter lid.
7
PERFORM BACKWASH PROCEDURE
Refer to page 11 for backwash instructions.
CLEANING | PRE-FILTER
Close drinking water dial to "close", then turn dark
Internal pre-filter
containing 3 stacked
mesh filters
11