Vestergaard LIFESTRAW MAX Manual Del Usuario página 9

MAKE SURE PRODUCT IS READY FOR USE
1
Ensure all hose connections, filter cartridges, and pre-filter lid are in place,
as any loose parts may cause leaking. Make sure the dark gray backwash
dial is in position 0.
2 TURN ON WATER SOURCE (HOSE)
ROTATE BLUE DRINKING WATER
3
DIAL TO OPEN POSITION
Water will start to flow from tap once the
blue drinking water dial is rotated to "open".
4
TURN OFF WATER SOURCE (HOSE) WHEN FINISHED
5
SWITCH BLUE DRINKING WATER DIAL TO CLOSE POSITION
Once finished and water source is shut off, switch blue drinking dial to the
"close" position.
NOTE: Once the dial is CLOSED, it may take a few seconds for water to stop flowing. Make sure
the internal hoses are emptied of water as much as possible.
The lid can ONLY be removed when the
system is off and the source water hose
is disconnected from the water inlet.
Do not remove the lid if the system is
on and the hose is connected to the
inlet. Opening the lid while the system
is under pressure could result in
damage to the product or injury.
EVERYDAY USE
CAUTION!
9