Descargar Imprimir esta página

Casselin CSAP514 Manual De Instrucciones página 16

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 29
Digital temperature controller:
- The regulator is located at the back of the device
- There are two keys to lower or raise the temperature
- The first liquid crystal indicator corresponds to the compressor, lit when the compressor is running for
cooling
- The second liquid crystal indicator corresponds to the defrost, lit when the automatic defrost is on
- This key corresponds to the LED lighting
1. Set the temperature: Press the button
to modify and store the displayed value. Push the button
room temperature.
2. If no other button is pressed within 10 seconds, cold room temperature will be displayed.
3. Lighting: Press the button
the button
and hold for 6 seconds to defrost or stop defrost.
4. Refrigeration LED: During refrigeration, the light is on; When the cold room temperature is constant, the
light is off; During delayed start, the light flashes.
5. Defrost LED: during defrost the LED is on; when defrosting stops, the LED is off. During the delayed
defrost display, the LED flashes.
6. Digital controller reset
When the screen displays "disorder", press the button for 2 seconds until the beep sounds, quickly press
the button for 6 seconds until the beep sounds again, the screen flashes for 3 seconds and restores
factory settings.
5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
, the set temperature is displayed. Push the button
, it lights up; press again, it stops. Manual defrost with stop/start: Press
to exit the setting and display the cold
EN
Where

Publicidad

loading

Este manual también es adecuado para:

Csap413Csap714Csap613Csap814Csap813