Publicidad
Maintenance
Periodic
maintenance
General maintenance
Oil
Air filter
Spark plug
Steering wheel brake pad
Gasoline tank and filter
Gasoline pipe
Valve free space
Combustion chamber
Troubleshooting
Problem
Cause
The handle is not in
• The handle extensions are not sitting right in
the right position.
their mounting supports.
• The knobs are not correctly tight.
The lawn mower
• No fuel.
would not start.
• Defective fuel.
• Defective spark plug.
• Spark plug wet with fuel.
• Blocked gasoline filter, carburetor misadjusted,
faulty ignition system, stuck valves, etc.
The motor has no
• Obstructed air filter.
power.
• Defective fuel.
• Blocked gasoline filter, carburetor misadjusted,
faulty ignition system, stuck valves, etc.
The lawn mower is
• The grass is thick or uneven.
cutting in an uneven
• The cutting height is not correctly adjusted.
fashion.
The lawn mower is not
• Wet grass gets stuck in the inner face of the
shredding correctly.
guard.
The lawn mower
• The motor axis is bent.
vibrates in excess.
• Unbalanced blade.
Before
Every 5 h or
each use
every month
Carry out
Check
Replace
Check
* Go to a
Every 50 h
Every 100 h
or 6 months
or each year
Replace
Replace
Adjust
Check
Clean
Adjust*
Authorized Service Center to carry out this service.
Solution
• Double-check the extensions edges are sitting
right in the mounting supports.
• Tighten the knobs and the blocking levers.
• Fill up the fuel tank.
• Drain the fuel tank completely and fill up with
new and adequate fuel.
• Adjust or replace spark plug.
• Remove spark plug and dry it before installing.
• Go to a
center to have it repaired or replaced.
• Clean the filter (See page 11).
• Drain completely the fuel tank and fill-up with
new and correct fuel.
• Go to a
center to have it repaired or replaced.
• Verify the cutting area.
• Adjust the cutting height into a higher position.
• Wait until the grass dries before mowing.
• Switch off the lawn mower and go to a
to repair.
• File both cutting edges in the blade so they are
exactly similar and to balance the blade.
Every
Every 250 h
200 h
or every 2 years
Replace
Replace*
Clean*
Authorized Service
Authorized Service
Authorized service Center
13
ENGLISH
Publicidad
