MARTINS Industries Impulse MX-P1 Manual página 5

BATTERY CHARGING
1- Remove the battery pack from the handle by pressing the battery lock button downwards and pulling the battery forward.
2- Check if the power voltage on the rating plate corresponds to the voltage available.
3- Slide the battery pack onto the battery charger. The red LED will illuminate to indicate that the battery is being charged.
When the charging process is finished, the red LED on the charging base will turn off and the green LED will illuminate.
It takes approximately 1 hour to fully charge an empty battery.
4- During charging, it is normal for the battery to warm slightly. If you cannot discharge the battery check:
• That the electrical outlet has voltage
• That the charger contacts are undamaged and making contact with battery leads
BATTERY CAPACITY INDICATOR
You can check the battery's power status by pressing the display button on the rear of the battery.
• All LEDs: The battery is fully charged
• Yellow and red LEDs: The battery has an adequate remaining charge
• Red LED: The battery is empty and needs recharge
USB POWER PORT
You can power any portable device that uses USB power port. The maximum output is 5 volts at 1.5 mA.
You cannot charge the battery using this port.
MAINTENANCE
Unplug tool and charger before cleaning
This product contains electronic components and should not be deposited with household garbage.
Dispose of the products through relevant recycling services.
• If the air system does not have an oiler, lubricate the air wrench daily with a few drops of spindle oil in the air inlet.
• Deposits in the wrench can reduce performance. If your model has a filter located in the air inlet, remove and
clean it as needed. Flush the wrench with gum solvent oil and allow to dry before use.
• Clean the wrench after use.
• When not in use, disconnect the wrench from the air supply, clean it and store it in a safe, dry, childproof location.