Listo RML50-50b2 Manual De Instrucciones página 13

Please clean the inside of the appliance and all the accessories before using it for the first time
(refer to the "Care & cleaning" paragraph).
i
nstallation location
The appliance must be installed in a dry, well-ventilated room.
The appliance's energy consumption and efficient operation are affected by the ambient
temperature.
The appliance must not be exposed to direct sunlight.
The appliance must not be installed next to a radiator, a stove or any other heat source.
Only install the appliance in a location where the ambient temperature corresponds to the
climate class for which it was designed.
The climate class is on the rating plate located on the inside of the appliance.
The appliance must be positioned such that the plug is accessible.
The table below shows the correct ambient temperature for each climate class:
Climate class
Your Listo RML 50-50b2 refrigerator is classified "SN/N/ST". If the room temperature is
below or above the indicated room temperature, the performance of your appliance may
be affected, and your food may spoil.
f
an
Make sure that air can always circulate behind and above the appliance. Please leave a clearance
of at least 10 cm between the top of the appliance and any kitchen equipment attached above
it; leave a clearance of 10 cm on each side and at least 5 to 7 cm between the back of the
appliance and the wall.
If the refrigeration appliance is installed next to another refrigerator or freezer, leave a clearance
of 5 cm on the sides, to prevent any condensation from forming on the outside of the appliance.
BEFORE FIRST USE
INSTALLATION
SN
N
ST
T
Room temperature
+10 to +32 °C
from +16 to +32°C
from +16 to +38°C
+16 to +43 °C
13 V.2.0