Publicidad
Idiomas disponibles
Idiomas disponibles
Initial Commissioning
Information on Initial Commissioning
Note: These Instructions describe how to perform initial commissioning
without provisioning.
1.
Mount the device feet (figure A 1 under Assembly).
Connect the device (figure A 2 under Assembly).
2.
The company logo is displayed for 2 to 3 minutes. The Message
key flashes. The system displays a message that it is searching for
provisioning files. The telephone's IP address is shown on the display at
the same time.
3.
Note the IP address.
Note: Make the settings afterwards as follows:
•
Navigate in lists using the direction keys
Enter numbers and characters, either using the keypad or the screen
keyboard.
Confirm your selection or entry with
Configuring the language and location
1.
Set the menu language.
• Softkey Country > Phone language
2.
Configure the location.
• In the phone: Location
3.
Set the language of the web interface.
• In the phone: Web interface
The menu First setup you can reach via Back
You can do one of the following:
• Configuring identity on the phone (chapterConfiguring identity on
the phone)
• Get access to the web interface to make settings via the web interface
(see chapter Open web interface).
− Softkey WebUI > Access > Web administration (https)
Configuring identity on the phone
1.
> Settings > Identities
2.
Select an Identity that has not been set up and enter the following data:
Note: To enter numbers, either press and hold down the number
keys or use the screen keyboard.
SIP Username
PBX
the internal number configured
for the phone
Example: 557
or touch the screen.
.
.
VoIP provider
The username configured for
the account
Example: phonenumber@provider.co.uk
Publicidad
