Novus Attenzia neo Manual De Instrucciones página 7

– Only use the light if it is in perfect condition. Ob-
serve the operating instructions, the usual regula-
tions and guidelines as well as the applicable safety
and accident prevention requirements.
– If the light malfunctions, immediately disconnect it
from the mains by pulling the plug.
– If the outer flexible cable for this light is damaged,
it must only be replaced with a cable which is avail-
able exclusively from the manufacturer or the man-
ufacturer's service representative.
– Only operate the product in closed spaces, at tem-
peratures between 10 °C and 25 °C (50 °F to 77 °F)
and at a non-condensing humidity between 15%
and 95%.
– Do not use the light in rooms where there is a risk
of explosion.
– Protect the light from shocks, impact, moisture and
excessive heat.
Prevent trapped heat.
– The light is not intended for use or installation by
persons (including children) with restricted phys-
ical, sensory or mental capabilities or a lack of ex-
perience and knowledge, unless they are working
under supervision or receive detailed instructions
about how to use the device from a person who is
responsible for safety.
– The light and packaging material are not toys.
– Do not touch the LEDs.
– Only operate the light from undimmed sockets.
– Ensure the light is stable. If the light tips over, it can
cause personal injury or material damage.
– If the light has a clamp fixing, it must not be
clamped onto pipes.
– Sufficient ceiling height must be ensured before
use on height-adjustable tables.
– Ensure that the connection cable does not pose any
danger. Trip hazard!
– Do not expose the cable to mechanical stress or
strain.
– Only the manufacturer or a service technician com-
missioned by the manufacturer may repair the
light.
– The light source of this light must only be replaced
by the manufacturer or a service technician author-
ised by the manufacturer, or other similar qualified
personnel.
– The light must be connected to a mains supply
with a protective earth conductor.
– The light must not be connected to the power sup-
ply until it has been fully installed.
– The light head must not be loaded.
1.6 Conformity
Conformity
Hereby, Novus DAHLE GmbH Breslauer Straße 34–38
49808 Lingen • Germany confirms that this product is
in accordance with the provisions of the Directives.
The full EU declaration of conformity can be found
under the following web address:
www.novus-more-space-system.com/ce
1.7 Cleaning and disposal
Cleaning and disposal
Risk of injury!
– Disconnect the light from the power supply.
– Do not clean the light with water. Risk of damage!
– To prevent damage to the light, check the compat-
ibility of the cleaning agent.
Dispose of the light properly in an environ-
mentally friendly way at an authorised col-
lection point. Do not dispose of any parts of
the light in domestic waste.
Positioning
When positioning the light, ensure that neither you
nor other people are dazzled by it, and that the light is
not reflected in a screen.
Attenzia neo + only:
When setting the daylight-controlled brightness,
avoid shadows and external light sources.
To ensure that the sensor technology functions op-
timally, you must make sure that the sensors are fa-
cing the working area.
7 / 44
80° - 100°
de
en
cs
es
pl
it
fr
nl
ar
ru