Descargar Imprimir esta página

EDM Product 07594 Manual De Instrucciones página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTRUCTIONS FOR REPLACE HEADS
ES
To change attachments, hold the clipper with the switch side facing you.
Rotate the accessory and remove it.
Place the replacement attachment on top of the clipper, then push down
PT
and attach.
USING THE CLIPPER
EN
REMOVE NOSE HAIR
▶ 1. Choose the right head for nose hairs
FR
▶2. Slide the switch to the "ON" position.
▶3. Carefully approach the cutting head to the nostril, simultaneously
rotating the device until all the hairs in the nose are removed.
▶4. Remove the cutter head from the nostrils again, while turning the
device.
▶5. If you experience any pain or discomfort while using this product,
STOP using it immediately.
▶6. Switch off the appliance by sliding the on/off switch.
▶7. Always clean the head after use and use the cap to protect the
head.
TRIM EYEBROWS
▶1. Choose the right head to trim the eyebrows.
▶2. Slide the switch to the "ON" position.
▶3. Trim the eyebrow hairs.
▶4. Disconnect the appliance by sliding the on/off switch.
▶5. Always clean the head after use and use the cap to protect the
head.
TRIM FACIAL HAIR/SIDEBURNS
▶1. Choose the appropriate head for your facial hair.
▶2. Slide the switch to the "ON" position.
▶3. Trim the hair in the desired area.
▶4. Switch off the appliance by sliding the on/off switch.
▶5. Always clean the head after use and use the cap to protect the
head.
Instruction manual
TRIM THE BEARD
▶1. Choose the right head to trim the beard.
▶2. Slide the switch to the "ON" position.
▶3. Trim beard hair.
▶4. Switch off the appliance by sliding the on/off switch.
▶5. Always clean the head after use and use the cap to protect the
CLEANING AND MAINTENANCE
▶Make sure the device is turned off.
▶ Never immerse the appliance in water or other liquids.
▶ Do not use pointed objects for cleaning.
▶ Do not use chemical or abrasive cleaning products.
▶ To remove hair from the cutting head, clean it with the cleaning
▶ Clean the manual clamp unit with a damp cloth.
▶ Clean the heads with water..
head.
brush.
ref. 07594

Publicidad

loading