Ego Power+ PS1000 Manual Del Operador página 20

MOUNTING AND ADJUSTING THE FRONT-ASSIST HANDLE
1. Stop the motor and remove the battery pack.
2. Loosen the wing nut and remove it with the clamp bolt from the front-assist
handle (Fig. 9a).
3. Position the slant of the assist handle forward towards the sawing end of
the machine (Fig. 9b). Press the handle onto the power head shaft within the
mounting zone between the shoulder strap loop and the telescopic pole sleeve
(Fig. 9c).
4. Insert the clamp block and assemble the clamp bolt with the wing nut (Fig. 9d).
5. Do not fully tighten the wing nut. Adjust the front-assist handle
the mounting zone (Fig. 9b). The handle should be adjusted so that your arm is
straight when using the pole saw.
6. Press down the lock lever and tighten the wing nut so that the front-assist handle
is secured from rotation or moving on the power head shaft.
9a
Front-assist Handle
Clamp Block
9c
20
56-VOLT LITHIUM-ION POLE SAW — PS1000/PS1000-FC
Lock Lever
Clamp Bolt
Wing Nut
Power Head Shaft
9b
Correct
Shoulder Strap Loop
9d
3
1
position within
Incorrect
Mounting Zone
2
4