Publicidad
Idiomas disponibles
Idiomas disponibles
where the cutting accessory or fasteners
may contact hidden wiring or its own
cord. Cutting accessory or fasteners contacting a
"live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
2) Safety instructions when using long drill
bits
a) Never operate at higher speed than the
maximum speed rating of the drill bit. At
higher speeds, the bit is likely to bend if allowed to rotate
freely without contacting the workpiece, resulting in
personal injury.
b) Always start drilling at low speed and with
the bit tip in contact with the workpiece.
At higher speeds, the bit is likely to bend if allowed to
rotate freely without contacting the workpiece, resulting
in personal injury.
c) Apply pressure only in direct line with the
bit and do not apply excessive pressure.
Bits can bend causing breakage or loss of control,
resulting in personal injury.
SAFETY WARNINGS FOR
BATTERY CELLS INSIDE
THE TOOL
a) Do not dismantle, open or shred cells.
b) Do not short-circuit charging terminal.
Do not store power tool haphazardly in a
box or drawer where charging terminal
may short-circuit each other or be short-
circuited by conductive materials. When
power tool is not in use, keep it away from other metal
objects, like paper clips, coins, keys, nails, screws or
other small metal objects, that can make a connection
from one charging terminal to another.
c) Do not expose power tool to heat or fire.
Avoid storage in direct sunlight.
d) Do not subject power tool to mechanical
shock.
e) In the event of battery leaking, do not
allow the liquid to come into contact
with the skin or eyes. If contact has
been made, wash the affected area with
copious amounts of water and seek
medical advice.
f)
Seek medical advice immediately if a cell
has been swallowed.
g) Keep power tool clean and dry.
EN
h) Wipe the charging terminals with a clean
dry cloth if they become dirty.
i)
Power tool needs to be charged before
use. Always refer to this instruction and
use the correct charging procedure.
j)
Do not maintain power tool on charge
when not in use.
k) After extended periods of storage, it may
be necessary to charge and discharge
the power tool several times to obtain
maximum performance.
l)
Battery gives its best performance
when it is operated at normal room
temperature (20 °C ± 5 °C).
m) When disposing of cells, keep cells
of different electrochemical systems
separate from each other.
n) Recharge only with the charger specified
by WESCO . Do not use any charger other
than that specifically provided for use
with the equipment. A charger that is suitable for
one type of battery may create a risk of fire when used
with another battery.
o) Keep power tool out of the reach of
children.
p) Retain the original product literature for
future reference.
q) Dispose of properly.
r)
Do not mix cells of different manufacture,
capacity, size or type within a device.
s) Do not use any cell which is not designed
for use with the equipment.
GENERAL SAFETY
WARNINGS
WARNING Read all safety warnings and
all instructions. Failure to follow the warnings
and instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
- This appliance is not intended for use by persons
(including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not
play with the appliance.
15
Publicidad
