DJI RONIN 4D FLEX Guia Del Usuario página 5

Disclaimer
Carefully read this entire document and all safe and
lawful practices provided before use.
Introduction
TM TM
The DJI RONIN 4D Flex enables the ZENMUSE
gimbal and camera to be used without being mounted
on the main body of DJI Ronin 4D. DJI Ronin Flex supports
Left and Right Hand Grip, High-Bright Main Monitor, DJI
RS Focus Motor (2022), and other accessories, providing
more flexible and lightweight shooting methods.
Gimbal Connector Module (Figure A-1)
1. Power Button
Press once to start/stop recording. Press and hold to
power on/off Ronin 4D.
2. Display Port
Used to connect the High-Bright Main Monitor.
3. Gimbal Ring (with Safety Lock)
For securing the gimbal.
4. Ronin 4D Hand Grip Adapter
For mounting Ronin 4D Left and Right Hand Grips. The
Hand Grip Adapter can be detached by loosening the
screw.
5. CAN Ports (USB-C)
For connecting Ronin 4D Left and Right Hand Grips,
and DJI RS Focus Motor (2022).
6. Cold Shoe
For mounting the High-Bright Main Monitor. The cold
shoe can be detached, and the 1/4"-20 screw holes
can be used to mount other accessories.
7. 1/4"-20 Screw Hole
For mounting accessories such as a tripod or unipod.
8. 3/8"-16 Screw Hole
For mounting accessories such as a tripod or unipod.
Main Body Connector Module (Figure A-2)
Installation
Attaching the Main Body Connector Module
(Figure B)
To attach the main body connector module, align the
red marks of the main body connector module and the
gimbal connector of Ronin 4D
module, and rotate clockwise until it clicks to indicate the
main body connector module is locked
gimbal ring .
Attaching the Gimbal Connector Module (Figure C)
Make sure the safety lock of the Ronin 4D Flex is in the
unlocked position . To attach the gimbal connector
module, align the red marks of the gimbal connector
4
TM
X9
, insert the connector
. Tighten the
module, gimbal ring, and the gimbal connector, insert the
gimbal and rotate gimbal ring counter-clockwise
Toggle the safety lock to the locked position
Attaching the Left and Right Hand Grip (Figure D)
Make sure the lever of the left hand grip is in the unlocked
position . Insert the left hand grip into the hand grip
adapter on the gimbal connector module
and then push the lever all the way down
right hand grip following the same instructions.
• Make sure the hand grips are firmly mounted.
Attaching the High-Bright Main Monitor (Figure E)
Attach the high-bright main monitor to the cold shoe of the
gimbal connector module and tighten the screw.
• It is recommended to mount the DJI RS Extended
Grip/Tripod for stability. Visit DJI Store for more
information.
Connection (Figure F)
1. Connect the main body module cable to the display
port of Ronin 4D .
2. Connect the high-bright main monitor cable to the
display port of the gimbal connector module
3. Connect the adapter cables to the CAN ports
(connected by default)
Press and hold the power button of the Ronin 4D Flex to
power on.
Using the Pan Axis Quick-Lock (Figure G)
It is suitable to mount the pan axis quick-lock when using
a tele lens mounted on devices such as a tripod (requires
a third-party accessory).
• Make sure Ronin 4D is powered off or in sleep
mode when mounting the pan axis quick-lock.
.
until it clicks,
. Attach the
.
.
.