Lionelo Stefi Plus Manual De Usuario página 6

• If you leave the child unattended in the cot, always make sure that the side
entrance is fastened with a zipper.
• Before replacing the base with the lowest one, it is necessary to remove the
support rails.
• All mounting elements should always be tight, connections should be regularly
checked and tightened if necessary.
• The cot can not be used by children who can get out of it themselves, it may
cause a fall and serious injuries or even death.
• WARNING - Only use the mattress sold with this cot, do not add a second
mattress on this one, suffocation hazards.
• The mattress is an integral part of the bed.
Assembly instruction
1.
Take the cot out of the bag and loosen the adhesive straps. Place the cot
on the floor and put the bag aside (see fig. 1).
2.
Separate the legs pulling them apart. Keep the central lock up. Otherwise
handrails will not fit in the right place (see fig. 2).
3.
Pull the middle part of each top rail covered with material so that they fit
into place. Start with the longer rails, and then the shorter ones (see fig. 3).
Note! So that the sides of the cot / handrails are properly blocked, the central blockade
of the floor must be raised upwards. The baby rails will not lock when the floor
is unfolded.
4.
Push the middle lock until the surface is completely flat (you will hear the
click sound) (see fig. 4).
5.
Place the mattress in the cot (see fig. 5). Fasten the mattress using Velcro
on the two short sides of the mattress (there are special openings in the
floor for fastening).
EN ‑ 6 ‑