Step 7 - Install Vent Covers - Haier HCH2400ACB Manual Del Usuario

4. Mount the range hood onto the mounting screws. When the hood has been
leveled, secure unit by tightening screws.
b
NOTE: The vent cover needs to be placed on some styles of range hoods before
you tighten the screws completely to secure the lips of the vent cover.
5. Attach 6" metal vent duct to the hood duct connector. Ensure that the damper
flaps are free to open. Seal all seams.

STEP 7 - INSTALL VENT COVERS

IMPORTANT: For Non-Vented (recirculating) installations, skip steps 1 and 2.
1. Center the mounting bracket on the plumb line, at the edge of the ceiling.
2. Using screws appropriate to the wall material, attach the bracket to the wall.
NOTE: If your ceiling is not even, mount the wall bracket at the lowest level
point.
3. Carefully loosen but do not separate the upper and lower sections of the vent
cover. The inside piece is the upper section and attaches to the wall at the
ceiling. The outside piece is the bottom section that rests on the range hood.
NOTE: Remove the white film from the vent covers, as needed, prior to
assembly and installation. Handle the vent covers gently to avoid scratching the
finish.
a
b
a
b
c
a
Mounting Screws
b
Mounting Slots
a
Ceiling
b
Wall
c
Plumb Line
15