Orbegozo PC 2017 Manual De Instrucciones página 10

PC 2017
Incremental weighing ("TARE" function)
Touching the TARE button will change the actual reading to "0". Also the symbol "T" will

appear in the display.
Now, you can add another ingredient to the bowl to be measured and the screen will show

the measure of this new ingredient.
If you remove this new ingredient, the screen will show "0" again.

If you remove all the ingredients from the scale, the screen will show a negative value with

the symbol "-". This negative value will correspond to the weight of the first ingredient.
To reset the weighing, press the TARE button again and the symbol "T" will disappear and

the screen will show "0" again.
Timer/Alarm function
Note: The product timer has a range from 00:10 to 99:50 minutes. The setted time will countdown
until "00:00". Once the countdown finishes, the alarm will start beeping and the "
shown on the screen.
Press the ON/OFF button to turn on the device.

Press the T-SET button, " " symbol will be shown on the screen.

Adjust the time by pressing UNIT (

Press the T-SET button again to confirm the setted time and start the countdown timer.

Press again the T-SET button to stop the timer.

Press the T-SET button for the third time to reset the timer to "00:00". The alarm symbol " "

will disappear.
Note: When the setted countdown timer finishes, the alarm will start beeping.
Press the ON/OFF button to stop the beeping and turn off the scale at the same time.

Ambient temperature function
When the device is turned on, the LCD screen will show the current ambient temperature. This temperatura
will be shown in °C.
Turning Off the device
Press the button ON/OFF to turn off the scale manually.

The scale will turn off automatically after 90 seconds of inactivity to save power.

CAUTION INDICATORS
Low battery
The "Lo" indication in the screen means the battery is low.
Overload
The "Err" indication in the screen means the weight on the scale is over the máximum weight
accepted by the scale (5 kg.).
) or TARE ( ) buttons.
" symbol will be
10