Descargar Imprimir esta página

Vito Agro VIR43E Manual De Instrucciones página 46

Ocultar thumbs Ver también para VIR43E:

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
5.4 - CHECK AND REPLACE
THE SPARK PLUG (FIG. R)
To ensure a proper engine operation,
the spark plug must be clean and
with adequate distance between the
electrodes.
There are several factors that can
affect the operation of the spark plug:
incorrect carburetor adjustment and
fuel mixture, and dirty air filter. These
factors cause deposits in the spark plug
electrodes, which leads to operating
problems and difficult start-ups.
If the unit has a low power or troubles
when starting, check the spark plug
before making any further checks.
1. Remove the cap (12), unscrew the
spark plug (12) with the supplied
wrench and check if it is clean. If dirty,
clean the soot with a brush;
2. If the spark plug is "wet", with excess
fuel, place a clean cloth over the spark
plug hole and pull the starter handle
several times without the spark plug;
3. Measure the distance between the
electrodes with appropriate tools. The
distance should be between 0.6-0.7
mm. If necessary, bend the electrode
until enough space is available;
4. Place the spark plug with your hand
to prevent damage to the wiring and
tighten to compress the sealing ring,
using the wrench provided;
5. If the spark plug does not produce
any sparks, replace it;
A loose spark plug can overheat
and damage the engine..
Always use the type of spark
plug recommended by the
manufacturer
(VIVELA5510).
improper use of a spark plug can
damage the cylinder.
46
5.5 - LUBRIFICATION
The unit does not require regular
lubrication; however the gearbox (11)
and rotation shaft (2) grease must be
checked frequently for a longer service
life.
5.6 - STORAGE AND CLEANING
Storage
Preparing storage for long periods is
vital to avoid problems and increase
the useful life of the unit.
Never store the machine with gasoline
in the tank. Depending on the region
and
storage
conditions,
can deteriorate and oxidize, causing
damages in the carburetor and fuel
system, difficult starts and clogging
caused by particle deposition.
Before storage proceed as follows:
1. Remove the gasoline from the tank;
2. Start the engine until it stops for lack
of fuel;
3. Remove the spark plug and add
2-stroke engine oil (5-10 cl) to the
cylinder through the spark plug hole;
4. Place a clean cloth over the spark
plug hole and pull the starter handle
to dispense the oil throughout the
cylinder;
5. Pull the starter handle slowly while
feeling some resistance. The piston
rises and the intake and exhaust valves
are closed. Leaving the engine in
this position will help protect against
internal corrosion;
6. Reinstall the spark plug;
An
Cleaning
The appliance must be thoroughly
cleaned after each use. Remove
any waste (grass, bush, threads)
accumulated in the cutting disc or in
the rotation screw.
A careful handling protects the device
and increases its service life.
6. ENVIRONMENT
SAFETY
The packaging is made of
recyclable materials, which can
be disposed on local recycling points.
Never place power tools in
the domestic waste!
According to the European Directive
2012/19
/EC
gasoline
electronic equipment waste and its
transposition into national law, power
tools must be collected separately
and delivered to the collection sites
provided for this purpose.
You can obtain information regarding
the disposal of the machine through
the person in charge for the recycling
in your city.
7. CUSTOMER
SERVICE
Tel.:
256 331 080
E-mail:
sat@centrallobao.pt
Site:
www.centrallobao.pt
on
electrical
and

Publicidad

loading

Este manual también es adecuado para:

Eko 43