Furrion VISION S+ FOS7HTAEM Manual De Usuario página 22

Change Profile
Current Profile Info
Profile Setting
System Setup Setting
Tap System Setup icon to skip to system setup setting page. Refer to the function
explanation of each menu in the table and change to your preferred settings.
Auto Dim
LCD Auto Off
Display
Settings
Motion Detect
50/60 Hz
CCD-0005512 Rev: 03-20-22
Camera Profile
Click to choose the camera profile that is right for your vehicle.
Click to view the camera profile to be selected and the number of camera to be
paired.
Change the connection status of each camera.
Camera Pairing
Check and make sure the camera is connected properly. See
"SETUP THE SYSTEM" section for detail.
View the connection status of each camera.
Camera Status
Parking
Click to adjust the setting of the parking guidance lines.
Guidance Lines
Default View
Screen View
Camera View
with Turn Signal
Camera Change the display setting of the camera, such as Rotate,
Settings Flip, Brightness, Contrast and Color.
System Setup
Enable or disable screen brightness automatic adjustment
function.
Set the LCD auto off time.
Change the setting of Motion Detect function. The monitor
will turn on automatically after any motion is detected while
the monitor in off mode. The higher the detection sensitivity
the easier the motion will be detected.
Set a suitable screen refresh rate for the monitor.
Indicates the camera is paired.
Indicates the camera is not paired.
Indicates the camera is paired but not connected.
Indicates the camera is paired.
Indicates the camera is not paired.
Indicates the camera is paired but not connected.
Change the screen time-out display of the
camera to single view or split screen view.
Enable or disable the camera view with
turn signal.
- 21 -