Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Intermittent / weak signal
icon appears
Blurry images on the monitor
Images too dark / bright on
the monitor
Night vision is poor or does
not function
Monitors Blue LED off with
no picture
SPECIFICATIONS
Note: Product specifications are subject to change without prior notice.
Vision S+ Monitor Specification
Resolution
Brightness
Contrast
Viewing Angle
Aspect Ratio
CCD-0005512 Rev: 03-20-22
Solution
Check if the camera antenna is fitted and secured correctly - it should be
vertical.
Large dense objects could be obscuring the signal. If possible, move the
objects.
Interference from electrical appliances may be affecting the wireless
signal. Turn off the appliances when using the system.
Interference from overhead power lines may be affecting the signal.
Try unpairing and pairing again.
Remove the protective film from the camera lens upon completion of
installation.
The camera lens may be dirty. Wipe them with a piece of soft and clean
cloth.
Some adverse weather conditions such as heavy fog, rain, floating dust
or mud splashes may either partially or entirely block the camera view.
Clean the camera lens immediately after driving to a safe place.
Adjust the brightness and contrast settings.
The image may be too bright when the camera lens are facing towards a
direct light source. This is not a malfunction.
The light sensor on the camera may be dirty or obstructed. Clean the
light sensor or remove obstacles.
If the ambient light is too strong, the night vision function may not
engage. This is not a malfunction.
Ensure that the camera is installed at least 2 inches away from marker
lights.
The camera has no power connected.
Ensure the tow vehicle is running.
Ensure the 7 way connector is connected.
1024 x 600
700cd/m2
CR:800
Left / Right 85°, Up 85°, Down 85°
16:9
- 25 -
Publicidad
