Publicidad
Idiomas disponibles
Idiomas disponibles
Aut om at ic Tuning
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 38.
1
Press TUNER to light the button up.
The last received station is tuned in.
2
Press FM / AM to select the FM or AM band.
3
Press TUNING + or TUNING –.
Press the + button to scan from low to high; press the –
button to scan from high to low.
When t he receiver reaches eit her end of t he
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
4
To continue scanning, press TUNING + or TUNING –
again.
Downloaded from:
https://www.usersmanualguide.com/
Preset Tuning
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 38.
Before tuning to preset stations, be sure to preset them by
performing steps on "Presetting radio stations" below.
Preset t ing radio st at ions
1
Press TUNER to light the button up.
The last received station is tuned in.
2
Tune in the station that you w ant to preset using
Direct Tuning (page 38)‚ or Automatic Tuning (this
page).
3
Press M EM ORY.
"MEMORY" appears in the display for a few seconds.
Do Steps 4 to 6 before "MEMORY" goes out.
4
Press SHIFT to select a memory page (A, B or C).
Each time you press SHIFT, the letter "A", "B" or "C"
appears in the display.
5
Select a preset number by pressing it (0 to 9).
If "MEMORY" goes out before you press the preset
number, start again from Step 3.
6
Press M EM ORY again to store the station.
If "MEMORY" goes out before you press the preset
number, start again from Step 3.
7
Repeat Steps 2 to 6 to preset another station.
To change a preset num ber t o anot her st at ion
Do Steps 1 to 6 to preset the new station to the number.
Note
If the AC power cord is disconnected for about one week, all the
preset stations will be cleared from the receiver's memory, and
you will have to preset the stations again.
EN
39
Publicidad
