SPECIFICATIONS AND PARAMETERS
ES
▶Rechargeable Electric Hair Trimmer
▶ Electric motor
PT
▶ Working voltage: 2.4V
▶ Working current: 600-800mA
▶ Specific voltage: 2.4V
EN
▶ Charging duration: 8 hours
▶ Input: 220/240V
FR
▶ Output: 3V 600mA
▶ special power adapter
HOW TO CHARGE THE BATTERY
▶Make sure the unit is turned off. It is not allowed to charge it when
it is on.
▶ Insert the connector into the hair clipper.
▶ Connect the charger to the power adapter (the indicator light will
turn on).
▶ It takes 8 hours for a full charge. The usage time with a charged
battery is 60 minutes.
Note: Please charge the device 10 hours before first use or if it has
not been used for more than half a year (this process activates
the battery). The indicator light may not turn on if the battery is
completely exhausted, it will turn on after a few minutes.
AFTER BATTERY CHARGE
▶Disconnect the charger from the power adapter.
▶ Remove the connector from the device.
▶ Please do not disconnect the charger by pulling on the cable, it may
be damaged
Instruction manual
HOW TO USE THE HAIR CUTTER
▶Insert the accessory you want according to your use.
▶ Turn on the device.
▶ Turn off the device after use and charge it if the battery is depleted.
▶If the battery is depleted it may be difficult to turn on the device. It
▶It is normal for the charger and the device to emit heat during
INSTRUCTIONS FOR ASSEMBLY AND
DISASSEMBLY
▶To install align comb frame with slots on both sides and press down.
▶ To remove, disconnect directly by pulling from the cutter slots.
▶ Adjust the position by turning the wheel on top of the hair clipper (to
▶ Hold the hair clipper, take out the set of parts to clean the hair
PRECAUTIONS
▶The cover can only be washed with water or a neutral soap solution.
▶ Do not put the hair clipper in water.
▶ It is normal for the hair trimmer to generate heat when charging or
▶ In case of damage to the cable, do not use the appliance. The cable
▶ Do not change accessories with the appliance on.
▶For good use and battery life, it should be charged at least 3 times
should charge for a few minutes.
charging
extend, turn the wheel back and forth for the opposite movement).
debris. Inject 2-3 drops of oil between the blade gaps to lubricate
them.
in use.
must be replaced by an authorized technical assistance service or
similar.
per month.
ref. 07599