Battery Status; Charging The Power Dome; Dc Charging In Your Vehicle Or Boat - Wagan Tech Power Dome Plex Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Power Dome
®

BATTERY STATUS

The voltmeter provides the current state of charge on the internal battery. It is the user's
responsibility to periodically monitor the battery's status and recharge every 3 months in addition
to recharging after each use.
1. Disconnect any input or output power cords and turn off all switches.
2. Press and hold the Battery Status button.
3. Read the voltmeter to determine battery status.
• < 12V: Battery is discharged, charge immediately
• ~ 12V: Battery should be charged before jump starting a vehicle
• > 12.5V: Battery is adequate for jump starting

CHARGING THE POWER DOME

ELECTRICAL SHOCK! Exposure to water may cause electrical shock� Exposure to
water and excessive moisture will also damage the unit and void the warranty�
Charge your Power Dome in an upright position for a full 48 hours before initial use� The
Power Dome can be charged continuously via AC adapter without damaging the internal battery.
In order to prolong the life of the Power Dome (as with all lead-acid batteries), be sure to fully
recharge the unit every 3 months even if the Power Dome has not been used.
AC Charging
Only use the AC charging adapter supplied with this unit� Make sure the supplied AC/DC
charging adapter is powered by the correct voltage (110V AC or 220V AC depending on your
country/region).
1. Make sure all Power Dome switches are off.
2. Open the dust cover on the charging jack.
3. Plug the DC end of the AC/DC charging adapter into the Power Dome's charging jack.
4. Connect the AC end of the AC/DC charging adapter to the wall outlet.
5. The charging indicator will light up during the charging process.
6. When charge is complete, disconnect the adapter from the AC outlet first, then from the
charging jack.
7. Replace the dust cover on the charging jack.

DC Charging in Your Vehicle or Boat

Only use the DC charging adapter supplied with this unit� Your vehicle engine must be
running while charging the Power Dome. Do NOT exceed 12 hours of continuous charging time.
1. Make sure all Power Dome switches are off.
2. Open the dust cover on the charging jack.
3. Plug the small end of the DC power cord into the Power Dome's charging jack.
4. Plug the large end of the DC power cord into an accessory (cigarette lighter) socket.
10
Plex by Wagan Tech
www.wagan.com
®

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

7561

Tabla de contenido