Air Compressor - Wagan Tech Power Dome Plex Manual De Usuario

Power Dome
®
6. Determine the ground system of your vehicle.
• If vehicle to be started has a negative ground system (this is most common):
a. Connect the red (+) cable clamp first to the vehicle's positive (red) battery terminal.
b. Next, connect the black (−) clamp to the vehicle chassis or a solid, non-moving,
metal vehicle component or body part. DO NOT clamp directly to negative battery
terminal or a moving part.
• If vehicle to be started has the positive battery terminal connected to chassis (this is rare
and usually found in older car models from the 1950s or earlier):
a. Connect the black (−) clamp first to vehicle battery's negative (black) terminal.
b. Connect red (+) clamp to vehicle chassis or a solid, non-moving, metal vehicle
component or body part. DO NOT clamp directly to positive battery terminal or a
moving part.
7. Observe the color of the Reverse Polarity Protection Indicator.
• If the light is RED, DO NOT TURN ON THE JUMPER SAFETY SWITCH!
a. Cable clamps need to be reversed.
b. Disconnect the black clamp first then the red clamp.
c. Reconnect and observe the indicator again.
• If the light is GREEN, turn on the Jumper Safety Switch.
a. Inside the vehicle, turn on the ignition switch and attempt to start the engine.
b. Crank a maximum of 3 seconds. If the engine does not start, wait 3 minutes before
the next attempt.
c. After the engine starts, turn off the Jumper Safety Switch.
d. Disconnect the clamps in the reverse order of connection prior to jumpstarting.
8. Be sure that the cables and clamps are securely stored.
9. Recharge the Power Dome as soon as convenient.

AIR COMPRESSOR

This Power Dome is equipped with an air compressor that can provide up to 260 PSI (pounds per
square inch) of pressure for a variety of uses such as vehicle tires and sports equipment.
CAUTION: Be careful not to over inflate, monitor the compressor gauge while inflating. Never
connect or disconnect the nozzle with the compressor operating. To avoid overheating, do
not operate the air compressor for more than 10 minutes at a time. After 10 minutes, allow the
compressor to cool for 15 minutes before using again.
Operation
In the event that the vehicle tire is completely flat, raise the vehicle using a recommended jack
before inflating the tire.
1. Before any tire inflation, look for manufacturer's recommended inflation pressure.
12
Plex by Wagan Tech
www.wagan.com
®