DeLonghi Pinguino F250 Instrucciones De Uso página 20

I 8-08-2001 9:30 Pagina 20
PREPARING THE INTERNAL UNIT
Install the appliance inside the room to be air
conditioned, usually near a window or a peri-
meter wall. The internal unit must be located
on the level. Also use the wheel blocks
supplied. The intake zone (intake grill
emission zone (outlet grill
unit should be kept clear of obstacles.
NB: Leave at least 30 cm between the wall
and the appliance.
POSITIONING THE CONNECTING SHEATH
4
The sheath connecting the external and
internal units can be passed:
a) Through the crack of a window or door left
ajar. Use the suckers
opening further.
b) Through a small crack (5.5 cm x 2.5 cm) in
the bottom of a door or the frame of a
window, using the sheath frame
vided.
USING THE RAPID COUPLINGS
(models F400 and F300 only)
As an alternative to the methods described
above, the sheath connecting the external
and internal units can be passed through a 6
cm diameter hole in a wall communicating
with the outside.
20
S e t t i n g u p
22
8
and
2
) of the internal
21
to prevent it from
20
pro-
Rapid couplings in the model F400
In this model, the connections of the external
unit must be disconnected as follows:
ELECTRICAL
CONNECTION
BLOCK GUARD
1) Unplug the appliance from the main.
2) Remove the handle by undoing the two
metric screws then remove the front panel.
3) Remove the "U"-stay by undoing the two
metric screws.
4) Remove the sheath clip by undoing the
two metric screws.
5) Use a number 24 spanner to undo the
rotating union on the coupling. At the
same time, use a number 21 spanner to
hold the end of the flexible pipe steady.
Repeat for the second union using a num-
ber 24 and a number 19 spanner.
6) Disconnect the condensate pipe from the
pipe fitting.
7) Undo the two self-tapping screws holding
the guard and remove the electrical con-
nection block.
Avoid tight curves in the connection sheath
SHEATH CLIP
"U"-STAY