DeLonghi Pinguino F250 Instrucciones De Uso página 23

I 8-08-2001 9:30 Pagina 23
Turning on and selecting the functions
CONNECTING TO THE ELECTRICAL MAIN
AND TURNING THE APPLIANCE ON.
1. Before plugging the appliance into the
electrical main, check that:
• mains voltage conforms to the value indi-
cated on the rating plate on the back of
the appliance;
• the socket and power line are adequate
for the required load;
• the socket is the right type for the plug,
otherwise have the socket replaced;
• the socket is connected to an efficient
earth installation. Failure to observe this
accident prevention rule absolves the
manufacturer of all liability.
Replacement of the power cable must be
carried out by qualified personnel.
2. Before setting the required function, check
that the switch on the timer
1 (manual).
If you wish to use the timer, position the switch
in the intermediate position
12
9
0
6
is in position
7
.
MANUAL
1
STOP
TIMER - SETTING THE TIME
As with all clocks, the programmer/timer must
be set to the right time. If it is 16.00, rotate the
pointers clockwise (follow the direction of the
arrow) until you reach 16.00 p.m..
NB: never rotate the face in the opposite
direction!
The timer is an electric clock and only
works while the unit is connected to the
mains. When it is unplugged or there is no
electricity, the timer stops (the clock is
"slow") and must be put right.
TIMER - PROGRAMMING
1) Set the times when the unit will function by
pushing the teeth in the required interval
towards the outside (each tooth repre-
sents 15 minutes).
2) Check that the timer indicates the exact
time (see setting the time).
3) Choose the required function according
to the instructions on the following page.
Period of operation
8
12
In this mode, the unit will repeat the set pro-
gramme every day.
N.B.: It is not necessary to modify the pro-
gramme to exclude "timer" operation. Just
turn the switch to 1 (manual).
Example:
from 7 to 9
23