Hayward POWER-FLO II Manual Del Usuario página 8

WARNING
WARNING
F NF C 15-100
D DIN VDE 0100-702
A ÖVE 8001-4-702
E UNE 20460-7-702 1993, REBT ITC-BT-31 2002
IRL Normas de cableado + IS HD 384-7-702
I CEI 64-8/7
LUX 384-7.702 S2
NL NEN 1010-7-702
P RSIUEE
WARNING
The pump is to be supplied by an isolating transformer or supplied through a residual current device (RCD) having a rated
residual operating current not exceeding 30 mA.
WARNING
objects away from openings and moving parts.
WARNING
units use properly grounded outlet.
WARNING
as required by electrical codes.
WARNING
box. Be sure to check the electric connections are tight and sealed before powering up. Replace all covers before operation.
WARNING
network and that the power supply cables matches the power and current of the pump.
WARNING
instructions can cause serious injury or death.
This document should be given to the owner of the swimming pool and must be kept by the owner in a safe place.
WARNING
sensory or mental capabilities, or lack of experience and knowledge, if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved.
WARNING
WARNING
WARNING
WARNING
persons in order to avoid a hazard.
WARNING
provide a full disconnection under overvoltage category III conditions must be incorporated in the fixed wiring in accordance
with the wiring rules.
WARNING
damaged. This can cause an electric shock. A damaged power cord or motor connection box must be replaced by a service
agent or a similarly qualified person immediately in order to avoid a hazard.
WARNING
drowning due to body entrapment on underwater drains. In some pool configuration, if a person's body covers the drain, the
person can be trapped by suction. Depending on your pool configuration, a SVRS may be required to meet local requirements.
Page 2 of 5
instructions can result in serious injury or death.
– Disconnect the pump from the main power supply completely before servicing the pump or filter.
– All electrical connections must be done by a qualified electrician according to local electrical standard.
– Be certain the machine is only plugged into a protected 230 V
– Children should be supervised to ensure that they do not play with the appliance. Keep ngers and foreign
– Motor must be suitably grounded. Connect ground wire to green grounding screw and for cord connected
– Use a motor bonding lug to connect motor with other bonded parts using the appropriate size conductor
– When making these electrical connections, refer to the diagram given under the lid of the motor terminal
– Make sure that the power supply voltage required by the motor corresponds to that of the distribution
– Read and follow all instructions in this owner's manual and on the equipment. Failure to follow
– The appliance can be used by children aged from 8 years and above and persons with reduced physical,
– Cleaning and user maintenance shall not be made by children without supervision.
– The pump is intended for continuous operation at Maximum Water temperature 35°C.
– Use Only Genuine Hayward Replacement Parts.
– If the supply cord is damaged it must be replaced by the manufacturer, service agent, or similarly qualified
– For disconnection from main power supply an external switch having a contact separation in all poles that
– Do not operate the swimming pool pump if the power cord or the housing of the motor connection box is
– This pool motor is NOT equipped with a Safety Vacuum Release System (SVRS). SVRS helps prevent
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
WARNING: Electrical Hazard. Failure to follow
FOR USE WITH SWIMMING POOLS
GB BS7671:1992
EW EVHS-HD 384-7-702
H MSZ 2364-702:1994 / MSZ 10-533 1/1990
M MSA HD 384-7-702.S2
PL PN-IEC 60364-7-702:1999
CZ CSN 33 2000 7-702
SK STN 33 2000-7-702
SLO SIST HD 384-7-702.S2
TR TS IEC 60364-7-702
Power-Flo II
outlet that is protected from short-circuits.
Rev. A