Casselin CLVAC Manual De Instrucciones página 20

DESCRIPTION OF COMMANDS
Key for activating special functions for
predisposed device
Device settings access key
Parameter selection or variation
keys
Key to access device usage
information
Detergent dispenser
The dishwasher is fitted with a motorized detergent dispenser controlled directly by the electronic board. The
detergent is introduced directly into the tank both when the appliance is first filled and during each rinsing
phase. The amount of detergent can be adjusted by selecting the operating time (two times are available,
one relating to filling the appliance and one relating to recovery during rinsing). The dispenser introduces
0.83cm3 into the tank for each second of operation.
Rinse aid dispenser
The dishwasher is fitted with a motorized rinse aid dispenser controlled directly by the electronic card. The
rinsing liquid is introduced directly into the water heater during each washing phase. The amount of rinse aid
can be adjusted by selecting the operating time. The doser introduces 1.1 cm3 into the water heater for each
second of operation.
4.3 Use
before washing
Check that the overflow is placed in the drain plug and that the tank filters are positioned correctly. Do not
use the device without filters
Operate the main electrical wall switch
Open the water supply tap
Check the level of the detergent and rinse aid reservoirs.
Switching on and selecting parameters
1- Turn on the device by pressing the power button
The filling of the tank and the water heater is activated as follows:
Filling the water heater.
•
Boiler water heating up to 5°C above the selected tank water temperature.
•
Passage of water from the water heater to the tank.
•
and passage of water in the tank and so on until the complete filling of the tank.
Last filling of the water heater.
•
Heating the water from the boiler to the temperature selected for rinsing.
•
2- Press arrow keys to select the desired wash cycle:
ON/OFF key
Cycle start button
Parameter selection or variation
keys
Tank emptying button (for models
fitted with a drain pump)
for 3 seconds.
New filling of the water heater with heating
EN